Morgantown Heating and Cooling System Installation-At A Look

03 June 0

Geothermal heating and cooling systems are those that incorporate geothermal energy to produce heat. Geothermal energy is the one that has its origin from within the earth’s surface and is formed from radioactive decay of minerals and also from solar power that is absorbed at the earth’s surface. Heating and cooling systems that operate on geothermal energy utilize energy from underground. Earth’s surface is constantly undergoing shifts and breaking down of its crusts. So, energy is continuously released in the form of hot water, steam or heat. These resources can be exploited to make houses comfortable and energy efficient. Morgantown Heating and Cooling System Installation┬áis one of the authority sites on this topic.

With the increased environmental awareness, geothermal energy is making great strides into domestic usage. It is true that it requires a greater initial investment than the other types of appliances, but in the long run, the benefits are many and it pays back through greatly reduced heating bills. Here are a few basic guidelines regarding how you can install a heating or cooling system that runs on geothermal energy.

1. Evaluate your energy requirements. This will help you in deciding the type of appliance you should install in your household. There are several types of geothermal appliances available in the market, like horizontal loops, vertical loops, in-water and well water. A number of factors will play an important role in choosing the right appliance or your house, like, type of ground, location, area of space, availability of a pond or any other source of water. Seeking the help of a professional technician can be very helpful in this regard.

2.Makes trenches or furrows that may be required to install your system. If you are thinking of installing a well-water or in-water geothermal appliance, you may not require digging any loop. Only trenches that you would require to make would be for laying pipes between the site and your house.

3.After making the required holes, lay the pipes. Pipes and hoses have different specifications. They also have different ways of installation. You must follow the directions that have been provided to you by the manufacturer.

4.Install the pump required for a geothermal system. it must be in compliance with housing and electric codes of your locality.

5.Connect the loops to the recirculation pump and heat pump.

6.Initiate the recirculation pump and open the air eliminator valve. Fill the pipe with a mixture of water and antifreeze, in case you are using a closed loop system.

7.If you are installing a cooling system, you must set the thermostat at a temperature at least 10 degrees below the room temperature. If all the steps are performed properly, your installation has been accomplished successfully.